Notifier Rp 2002 Manual

Ds1307 bascom program. Canadian DN-60444:B1

• Notifier Rp 2002 Manual Free
• Notifier Rp 2002 Manual 2
• Notifier Rp 2002 Installation Manual
• Notifier Rp 2002 Manual Instructions

We would like to show you a description here but the site won't allow us.

RP-2002C

Agent Release Control Panel

RP-2002 Series Manual P/N 53039:D1 2/28/2011 Installation Precautions Adherence to the following will aid in problem-free installation with long-term reliability: WARNING - Several different sources of power can be connected to the fire alarm control panel. Disconnect all sources of power before servicing. We would like to show you a description here but the site won't allow us. Notifier Rp-2002 User Manual Manual delphi skyfi2 user manual 2005 acura rl timing cover seal manual notifier rp 2002 manual 1997 yamaha p175tlrv outboard service repair maintenance manual factory 1998 yamaha xvt700 wave venture owner s manual omc evinrude control box manual canon jx201p manual pltw midterm exam answer key lg lrfc22750tt. Notifier RP 2002 Manual. These files are related to Notifier RP 2002 Manual.Just preview or download the desired file.

Conventional Releasing Panels

General

The RP-2002C is a six-zone FACP for single and dual hazard agent releasing applications. The RP-2002C provides reliable fire detection, signaling and protection for commercial, industrial and institutional buildings requiring agent-based releasing. The RP-2002C is compatible with System Sensor's i3 detectors which are conventional smoke detectors that can transmit a maintenance trouble signal to the FACP indicating the need for cleaning and a supervisory ‘freeze' signal when the ambient temperature falls below the detector rating of approximately 7.22°C. In addition, the control panel is compatible with conventional input devices such as two-wire smoke detectors, four-wire smoke detectors, pull stations, waterflow devices, tamper switches and other normally-open contact devices. Refer to the Notifier Device Compatibility Document for a complete listing of compatible devices.

Four outputs are programmable as NACs (Notification Appliance Circuits) or releasing circuits. Three programmable Form-C relays (factory programmed for Alarm, Trouble and Supervisory) and 24 VDC special application resettable and non-resettable power outputs are also included on the main circuit board. The RP-2002C supervises all wiring, AC voltage, battery charger and battery level.

Activation of a compatible smoke detector or any normallyopen fire alarm initiating device will activate audible and visual signaling devices, illuminate an indicator, display alarm information on the panel's LCD, sound the piezo sounder at the FACP, activate the FACP alarm relay and operate an optional module used to notify a remote station or initiate an auxiliary control function.

Features

•Listed to Standard ULC-S527-99.

•Designed for agent releasing standards NFPA 12, 12A, 12B, and 2001.

•Meets International Building Code (IBC) seismic requirements.

•Disable/Enable control per input zone and output zone.

•Extensive transient protection.

•Dual hazard operation.

•Adjustable pre-discharge, discharge and waterflow delay timers.

•Cross-zone (double-interlock) capability.

•Six programmable Style B (Class B) IDCs (Initiating Device Circuit).

•System Sensor i3 series detector compatible.

•Four programmable Style Y (Class B) output circuits - (special application power).

•Strobe synchronization:

–System Sensor

–Wheelock

•Three programmable Form-C relays.

•7.0 amps total 24 VDC output current.

•Resettable and non-resettable output power.

•Built-in Programmer.

•ANN-BUS for connection to optional devices (up to 8 total of any of the following):

–N-ANN-80 Remote LCD Annunciator

–N-ANN-I/O LED Driver

–N-ANN-S/PG Printer Module (only one allowed per panel)

–N-ANN-RLY Relay Module

–N-ANN-LED Annunciator Module (built-in)

•80-character LCD display (backlit).

•Real-time clock/calendar with daylight savings time control.

•History log with 256 event storage.

•Piezo sounder for alarm, trouble and supervisory.

•24 volt operation.

•Low AC voltage sense.

•Outputs Programmable for:

–Releasing Circuits or NACS

•NACs programmable for:

–Silence Inhibit

–Auto-Silence

–Strobe Synchronization

–Selective Silence (horn-strobe mute)

–Temporal or Steady Signal

–Silenceable or Non-silenceable

–Release Stage Sounder

•Automatic battery charger with charger supervision.

•Optional Trim Ring TR-CE (red) for semi-flush mounting the cabinet.

•Optional N-CAC-5X Class A Converter Module for Outputs and IDCs.

•Optional 4XTM Municipal Box Transmitter Module.

•Optional Digital Alarm Communicators (411, 411UD, 411UDAC).

•Optional ANN-SEC card for a secondary ANN-BUS

PROGRAMMING AND SOFTWARE:

•Custom English labels (per point) may be manually entered or selected from an internal library file.

•Programmable Abort operation.

•Three programmable Form-C relay outputs.

•Pre-programmed and custom application templates.

•Continuous fire protection during online programming at the front panel.

•Program Check automatically catches common errors not linked to any zone or input point.

USER INTERFACE:

•Integral 80-character LCD display with backlighting.

•Real-time clock/calendar with automatic daylight savings adjustments.

•ANN-Bus for connection to annunciators.

•Audible or silent walk test capabilities.

•Piezo sounder for alarm, trouble, and supervisory.

Controls and Indicators

LED INDICATORS

•FIRE ALARM (red).

•SUPERVISORY (yellow).

•TROUBLE (yellow).

•AC POWER (green).

•ALARM SILENCED (yellow).

•DISCHARGED (red).

Notifier Rp 2002 Manual Free

•PRE-DISCHARGE (red indicator).

•ABORT (yellow indicator).

CONTROL BUTTONS

•ACKNOWLEDGE.

•ALARM SILENCE.

•SYSTEM RESET (lamp test).

•DRILL.

AC Power – TB1

•RP-2002C:120 VAC, 60 Hz, 3.66 amps.

•Wire size: minimum #14 AWG (2.0 mm2) with 600V insulation.

•Supervised, nonpower-limited.

Battery (sealed lead acid only) – J12:

•Maximum Charging Circuit - Normal Flat Charge: 27.6 VDC @ 1.4 amp. Supervised, nonpower-limited.

•Maximum Charger Capacity: 18 Amp Hour battery (two 18 Amp Hour batteries can be housed in the FACP cabinet. Larger batteries require separate battery box such as the BB-26 or NFS-LBBR).

•Minimum Battery Size: 12 Amp Hour.

Initiating Device Circuits - TB4 and TB6

•Zones 1 - 5 on TB4.

•Zone 6 on TB6.

•Supervised and power-limited circuitry.

•Style B (Class B) wiring with Style D (Class A) option.

•Normal Operating Voltage: Nominal 20 VDC.

•Alarm Current: 15 mA minimum.

•Short Circuit Current: 40 mA max.

•Maximum Loop Resistance: 100 Ohms.

•End-of-Line Resistor: 4.7K Ohms, 1/2 watt (PN 71252).

•Standby Current: 4 mA.

Refer to the Notifier Device Compatibility Document for listed compatible devices.

Notification Appliance and Releasing Circuit(s) - TB5 and TB7

•Four Output Circuits.

•Style Y (Class B) or Style Z (Class A) with optional converter module.

•Special Application power.

•Supervised and power-limited circuitry.

•Normal Operating Voltage: Nominal 24 VDC.

•Maximum Signaling Current: 7.0 amps (3.0 amps maximum per NAC).

•End-of-Line Resistor: 4.7K Ohms, 1/2 watt (PN 71252).

•Max. Wiring Voltage Drop: 2 VDC.

Refer to the Notifier Device Compatibility Document for compatible listed devices.

Form-C Relays - Programmable - TB8

•Relay 1 (factory default programmed as Alarm Relay)

•Relay 2 (factory default programmed as fail-safe Trouble Relay)

•Relay 3 (factory default programmed as Supervisory Relay)

•Relay Contact Ratings:

–2 amps @ 30 VDC (resistive)

–0.5 amps @ 30 VAC (resistive)

Auxiliary Trouble Input – J6

The Auxiliary Trouble Input is an open collector circuit which can be used to monitor external devices for trouble conditions. It can be connected to the trouble bus of a peripheral, such as a power supply, which is compatible with open collector circuits.

Special Application Resettable Power - TB9

•Operating Voltage: Nominal 24 VDC.

•Maximum Available Current: 500 mA - appropriate for powering 4-wire smoke detectors (see note).

•Power-limited Circuitry.

Refer to the Notifier Device Compatibility Document for compatible listed devices.

NOTE: Total current for resettable power, nonresettable power and Output Circuits must not exceed 7.0 amps.

Special Application Resettable or Nonresettable Power - TB9

•Operating Voltage: Nominal 24 VDC.

•Maximum Available Current: 500 mA (see note 1).

•Power-limited Circuitry.

•Jumper selectable by JP31 for resettable or nonresettable power.

Refer to the Notifier Device Compatibility Document for compatible listed devices.

Notifier Rp 2002 Manual 2

notifier rp-2002 wiring diagram
fire lite rp 2002
notifier rp-1002 installation manual
notifier rp 1001
notifier rp-2002 data sheet
notifier id 2002 manual
notifier programming manual
notifier sfp 2402 installation manual

Notifier Rp 2002 Installation Manual

6 Mar 2017 Refer to the Notifier Device Compatibility Document for a com- plete listing of compatible The RP-2002E offers the same features as the RP-2002 but Custom English labels (per point) may be manually entered or selected E6. P/N 53049:E6. ECN 17-034. Document 53049. 1/26/2017. Rev: Agent Release Control System. MRP-2002. MRP-2002E. MRP-2002C. Instruction Manual The RP-2002E offers the same features as the RP-2002 but allows may be manually entered Refer to the Notifier Device Compatibility Document for listed or manual notifier rp 2002 manual honeywell notifier nfs 320 manual notifier. For immediate Series parts manual s in the Box Royal RP Pro Electronic. Thesaurus Notifier Conventional Releasing Free PDF Download at Fire Alarm Resources, Your Home for Free Fire Alarm Deluge – Preaction Control Pane · RP-2002(E) smoke detectors, heat detectors, manual pull stations, audible warning . MRP-2002 & MRP-2002E P/N: 53049:A1 5/01/08. Product RP. 2001U. Lwire.cd r. 4XTMF. CAC-5X ground stud. Power-limited Circuits (Class 2). Nonpower- limited. AFP-200(AUS) Installation & Programming Manual · AFP-2800/2802 Install, Operation & Programming Manual · AFP-2800/AFP-3030/NCA-2 Mixed Network RP-2002 is a UL listed six-zone fire alarm control panel for single and dual hazard agent releasing applications, providing fire detection, signaling and protection 23 Dec 2015 notifier rp-2002 instruction manual NOTI FI E. R®. by Honeywell smoke detectors, heat detectors, manual pull stations, audible. warningOperating instructions • Read online or download PDF • Notifier RP-2002 User Manual.

Notifier Rp 2002 Manual Instructions